Please note that our Terms & Conditions and Privacy Notice are applicable.
Verified seller
Chris Potgieter
Selling for 3+ years
Total Ads118
Active Ads9
Seller stats
118Total Ads
8.16KTotal Views
Verified information
This indicates that Gumtree has taken reasonable steps to verify the authenticity of the Seller’s profile.
Read More
Read More
Identity (SA ID/Passport)
Mobile number
Email address
9 Active Ads
3
Only best here.
R1000 for the lot.
Aimed at Carp fishing.
Full hooksets for farm dam Tilapia.
A few old school Rapala lures, etc.
1d
VERIFIED
3
Gilfox organizers Qty 2.
Perfect condition.
One is fully kitted for Carp fishing at venues like Wonderland 45, old Footloose and Trout Hunters in Gauteng. Daiich hooks galore, etc.
Phone me on Whatsapp or use this app to chat.
1d
VERIFIED
2
Bait runners for carp fishing.
Okumo Longbow II 650 (LBII-650). Qty 4
Perfect condition. One of these has never been used.
2d
VERIFIED
5
Shimano Vengeance 8ft carp rods. Qty 3
Perfect condition.
110mm carry tube included.
Phone me on Whatsapp or use this app.
2d
VERIFIED
9
Tried and tested aluminium construction that does not fall over; never-ever.
Fully adjustable for 8 to 12ft rods (see many photos).
Extras included:
Black and white rubber rod clips and 4x GILFOX bait alarms.
Phone me on Whatsapp. Or use this app.
2d
VERIFIED
5
New D.I.D (Rossi Fan-edition X VR46) 428 X 130 chain.
Brand New. Never fitted. Chartreuse link. Stunning looker. This is a top notch X-ring sealed chain (The o-ring cross section is X-shaped).
Size is genuine 428, with 130 plates. But due to its slightly heavier construction, it will foul your casing on any over-sized sprocket. Standard front sprockets are fine though. Don't modify your engine casing, it's too risky?
If you are looking to re-sell, the packaging is in mint condition. All the VR46 fan edition stickers are inside the box.
I run the exact same chain on my current bike. In two years, I did not see any stretch whatsoever and no rust either. More than you can expect from any good 428 chain.
21d
VERIFIED
1
I don't fit used parts. I don't run a scrapyard.
Some machines are worth restoring to serve as backup.
I do front loader drum restorations and motor brush replacements.
I source and fit new bearings, spiders and custom spider shaft seals.
Note. If unavailable, carbon brushes can be manufactured in Gauteng.
Quote acceptance before repairs.
3mo
VERIFIED
2
Here we mostly deal with low cost items with design flaws. I do not repair those. And there is no charge for the investigation.
Bring your small electrical appliances, microwave ovens, hammer drills, angle grinders and 2-stroke brush cutters, etc.
My rates remain low.
3mo
VERIFIED
4
Brush cutter engine and carburettor rebuilds.
General brush cutter repairs.
Please Note. There is a free but MANDATORY compression test at receiving, performed before you.
Written quote acceptance on Whatsapp before work may commence.
Due to all-too-common operator tampering, I highly recommend free teaching of brush cutter carburettor tuning during the collection field test. However, I find it necessary to place "your" custom setting sticker on the puller cover. This helps.
3mo
VERIFIED