Launch X431 ProS Elite Full System Diagnostic Tool With 32+ Special Functions

Launch X431 ProS Elite Full System Car Diagnostic Tool + Bi-Directional Control and 32+ Special Functions

LAUNCH X431 PROS ELITE Performs Advanced Resets/Calibrations/Routine Tests for 10000 Car Models

• Oil Maintenance Reset: Reset the oil life system and turn off the oil light to start a new cycle

• Brake Reset: Use the LAUNCH scanner to reset the brake pad in the following cases: a) the brake pad and brake pad sensor are replaced; b) the brake pad indicator lamp is on; c) the brake pad sensor circuit is in short-circuit; etc.

• Immobilizer Reset: Disable the lost keys and add new keys & remote control for vehicles with low-grade anti-theft systems.

• Steering Angle Reset: Reset the steering angle to zero to keep the car running straight.

• TPMS Reset Database: Relearn the tire pressure sensor ID with the vehicle after replacement.

• Battery Matching: Re-match the battery control module and motoring sensor. • Adblue Reset: Reset urea is needed after replacing or filling diesel exhaust fluid (vehicle urea).

• Air / Fuel Reset: Reset urea after the diesel exhaust treatment fluid is replaced or filled up.

• NOX Sensor Reset: Reset catalytic converter learned value stored in ECU

• Sunroof Reset: Reset sunroof locking & closing, closing on rainy days, slide/tilt sunroof memory function, outside temperature threshold, etc.

• ABS Bleeding: Vent the air of a brake system to restore ABS brake sensitivity

• Throttle Matching: Initialize the throttle actuators to the default state

• Headlamp Reset: Initialize the adaptive headlamp system

• Injector Coding: Code the injector after replacing or adjusting it to correct the fuel injection volume of each cylinder more accurately

• Seat Calibration: Calibrate the memory in replaced or repaired seats

• Windows Calibration: Perform door window matching to recover ECU initial memory

• Electrical Throttle Relearn, D-P-F Regeneration, Air Level Calibration, Crank Position Sensor Adaptive Learning, Gearbox Relearn, Language Change, Tire Reset, Windows

Bi-directional Control (Active Test):

LAUNCH bi-directional scan tool can send commands directly to vehicle modules and perform various active tests to accurately figure out whether a specific system, component, or subsystem in certain parts goes well or not, without using the vehicle controls.

Examples of active tests are as follows:

A/C compressor clutch relay, Active grille air shutter system, Auto start/stop, Camshaft position actuator system, Compression test, Cooling fan on/off, Engine controls ignition relay, Engine speed/throttle on/off, EVAP emission system, Fuel control loop status, Close/Open fuel system, etc