New PVC Banner Welders PVC Welding Solutions Thermo Bonding Machine

The Banner Welder is the ideal automatic hot-air welder used for thermo-bonding signage banners, truck curtains, jumping castles, inflatable boats, etc.

The hot air welder fuses an overlap of 25-40mm making the join unbreakable. The thermal bonding process is a preferred choice over the glue.

A good companion for a painting machine:
- Poster Heat Jointer Machine may join disjunct advertising poster surface without mucilage.
Know to all, the way to bond disjunct advertising poster surfaces, we usually use mucilage, such as the 502 glue to join them together in one, but the means have a lot of disadvantages, such as:

Almost all of these kinds of the bond are harmful to human health.
When work, the operation is slow and is not too satisfied in strength with the glue, to get good strength, usually, we must proceed a special handling, such as whet the surface to make the surface not smoothed, so it may cost more workers.
The air temperature may influence the stick strength, in a low-temperature environment, the bond effect may be bad. The Heat-Jointer Machine Without Mucilage will be a more efficient companion for advertising material instead of the 502 glue.
It can nicely solve the above existent problems, and may save more manpower and work field, for example, a PVC jointed painting with 200 meters long surface can be easily coalesced together and well-matched, all the works can be well finished by a single person on only a heat-resistant and smooth base ground about 30 square meters.

The machine is designed self-moveable, the volume is small, the whole weight only 9 kilogram, the working temperature, and self-move speed is adjustable;

The Heat Joiner Machine, to join disjunct poster banner without mucilage which is constructed simple, easy to maintain, The volume is small, the whole weight only 9 kilogram, the working temperature, and self-move speed is adjustable; the operation is also simple, and needs not much guide to operate.

When using:
- Immobilise both ends of each disjunct poster surface with something such as a stick belt or clamp, and leave about 30-40mm wide overlap edge on each disjunct poster surface edge.
- Turn on the machine, prepare to warm up about 2 minutes
- Bring up the machine, and place the roll at the end of the overlap edge
- According to the quality and thickness of the poster surface material, consider the ground circumstance, adjust the proper temperature and speed, handle the Fuse machine Gun down and insert it between the two poster banner edges, then the machine starts running, after go pass the overlap edge, the two disjunct banners will be well joined in one.
Application:
- Laminate and bond up disjunct flat painting surface made of heat-melted material, such as outdoor advertising poster, PVC cloth & PE fabric Canvas, outdoor poster banner, plastic surface, Sailcloth, etc.
- The wind power can adjust, if you weld thick flex, choose high wind power; if you weld thin flex, then choose low wind power.
- It can turn off automatically when no people operate. If no work in 15minutes, it will turn off the heater at first, and after more than 3 minutes, it will turn off the power automatically.

Specification:
- Alternant electric voltage: 220V/50Hz
- Upper limit power: 2000W, average 800W
- Adjustable work temperature: 50-600?
- Adjustable: self-move speed 0.8-15M/per minute
- Whole weight: 10 kilogram
- Splicing width: 2cm - 5cm

Items Available: 3
Stock ID: Banner Welder


www.discovery-products.co.za
www.sa-sauna.co.za
www.massagechairs.co.za
www.poolheat.co.za