landbou landwyd Lift Disk Harrows

INFORMATION

THE HEAVY DUTY LIFT DISC HARROW ARE BUILT FOR THE TOUGHEST CONDITIONS WITH A GOOD CUTTING AND MIXING ABILITY OF THE SOIL AND MATERIAL.

THE DISC GANG CONSISTS OF 22” AND 24” DISCS DEPENDING OF THE WITH AND ALL HAVE HEAVY DUTY OIL/GREASE TYPE BEARING UNITS.

EASY ANGLE ADJUSTMENT COMMENCES BY ONLY A FEW BOLTS TO GET DIFFERENT CUTTING ANGLES ON THE DISCS.

A HEAVY DUTY FRAME FOR UNEVEN GROUNDS AND FOR THE TOUGHEST OF CONDITIONS.

DISCS SCRAPERS ARE ON EVERY DISC TO PREVENT THE DISCS FROM CLOCKING.

OPERATING PROCEDURE

TIGHTEN ALL FASTNERS ON THE HARROW AND TEST THAT THE DISC ASSEMBLIES ROTATE FREELY.

RETIGHTEN DISC HARROW BLADE ASSEMBLY BOLTS AFTER 10-15 MINUTES OF OPERATING.

PICK THE HARROW UP OF THE GROUND BEFORE TURNING WITH THE TRACTOR

ADJUSTMENT OF HARROW PEPTH

ADJUST THE ANGULAYITY OF THE TWO DISC GANGS, AND THE HARROWING DEPTH WILL BE DEEPER ACCORDING TO THE INCREASE IN ANGULARITY. THE ANGULARITIES OF THE FRONT AND REAR GANGS SHOULD FIND THEIR LEVEL ON THE SAME GRADUATED LINE, THAT IS, THE ANGULATITY OF THE REAR DISC ASSEMBLY IS 3’ BIGGER THAN THE FRONT DISC ASSEMBLY.

TO INCREASE THE HARROWING DEPTH, THE DOWN SUSPENTION POINT MAY BE ADJUSTED UPWARD AND THE UP SUSPENTION POINTED DOWNWARD.

THE ADJUSTMENT OF THE CROSS LEVEL AND THE LONGITUDINAL LEVEL

THE ADJUSTMENT OF THE CROSS LEVEL AND THE LONGITUDINAL LEVEL OF THE HARROW CAN BE SOILED THROUGH THE ADJUSTMENT OF THE SUSPENSION HANGING ROD OF THE TRACTOR AND THE LENGHT OF THE DRAWROD.

TO RAZE THE DEFLECTING HITCH

GET THE SUSPENTION DRAW ROD OF THE TRACTOR LONGER, OR MAKE THE TWO DISC ASSEMBLIES MOVE IN THE SAME DISTANCE IN THE OPPOSITE DIRECTIONS OR DECREASE THE ANGULARITY OF THE FRONT ASSEMBLY SO AS TO RAZE THE DEFLECTION HITCH

ADJUSTMENT OF SCRAPERS CLEARANCE

THE CLEARANCE BETWEEN THE SCRAPERS AND THE CONCAVE SIDES OF THE DISCS SHOULD BE KEPT WITHIN THE RANGE OF 1-8mm.

IF THE SOIL MOISTURE CONTENT IS HIGH, OR IF THERE ARE MANY WEEDS ON THE LAND, THIS CLEARANCE SHOULD BE AS SMALL AS POSSIBLE

MAINTENANCE

WASH THE BEARINGS AND THEN LUBRICATE THEM WITH GREASE AND CHECK ALL FASTNERS.

It reduces labouring time and cost.

Look no further for quality, this product surely kicks the dust in the eyes of most in its class and range,

Our products are leading top of it's class in design, precision, strength and durability!

For more info or specs please whatsup or contact us on the following numbers:

Elzette: 081 485 1909

Petro: 064 559 0385